Introduction
This guide will demonstrate the proper way to disassemble a barbell.
-
-
Snap Ring Pliers
-
Safety Glasses (not shown)
-
-
-
While placing a hand over the sleeve end, carefully pinch and remove the outer snap ring.
-
-
-
Using the same precautions in the previous step, carefully remove the inner snap ring with the snap ring pliers.
-
-
-
Push the bar sleeve back towards the center of the shaft until it stops (a little less than an inch of movement).
-
Remove the following items (in order):
-
Full Washer (1x)
-
Shim Washer (0x-2x)
-
Split Washer (2x)
-
Full Washer (1x)
-
-
-
Carefully slide the sleeve off the bar shaft.
-
With a clean rag or paper towel, wipe off the excess oil from the bar shaft and the two bushings located inside of the bar sleeve.
-
Wipe the excess oil off all hardware components.
-