-
-
Loctite 648
-
End cap insert tool
-
Nitrile gloves
-
-
Use the insert tool to insert the end cap (without loctite)
-
Make sure the end cap is easy to screw in, if it gets stuck remove and clean the threads with a brush
-
If the end cap is easy to screw in and out, remove end cap and go to next step.
-
-
Open Loctite 648 kit, snap tube neck below cap.
-
Apply (1) drop of Loctite to the threads on the sleeve
-
Rotate sleeve 180° and apply another drop of Loctite to the threads on the sleeve. Each sleeve should have (2) drops of Loctite on the threads.
-
Make sure you don't apply Loctite near the hardware. If you get it there, clean with a damp towel.
-
-
Grab end cap with one hand. Use other hand to apply a 1" bead of Loctite to the end cap. Make sure the threads are covered on side you install first.
-
Rotate end cap 180° and apply a second 1" bead of Loctite. Each end cap should have approximately 2" of Loctite.
-
-
Embed this guide
Choose a size and copy the code below to embed this guide as a small widget on your site / forum.
Preview