Skip to main content

You're viewing a previously published revision of this guide.  View latest revision

Older Newer

Introduction

General Gym Cleaning and Disinfecting Guidelines:

1. Wear disposable gloves, a mask, and eye protection to clean and disinfect.

2. Ensure that there is adequate ventilation during cleaning and disinfecting.

3. Use an alcohol free, phenol free, bleach free, and ammonia free cleaner or wipe containing an EPA approved disinfectant, such as GymWipes Antibacterial product.

4. If a surface is visibly covered in chalk or dirt, clean that surface prior to using a disinfectant.

5. Not all surfaces need to be cleaned or disinfected with the same frequency. Areas that are frequently touched such as door handles, barbells, pull-up bars, dumbbells and medicine balls should be cleaned after every use, while other surfaces that are not touched as often can be cleaned less frequently.

6. A searchable list of CDC/EPA approved disinfectants that are effective against COVID-19 can be found here: https://www.epa.gov/pesticide-registrati...

7. A list of CDC/EPA approved disinfectants that are effective against disease causing bacteria can be found here: https://www.epa.gov/pesticide-registrati...

  1. If chalk, debris, or sweat remain on the dumbbells, follow these steps:
    • If chalk, debris, or sweat remain on the dumbbells, follow these steps:

    • If there is chalk on the dumbbell, remove it using a nylon bristle brush.

    • Chalk can hold moisture and bacteria and therefore must be removed prior to applying a cleaning product.

    • Clean the entire dumbbell using a solution of mild soap or detergent and a clean cloth/paper towel.

    • Dry the dumbbell using a clean cloth.

  2. Wet the shaft with an alcohol free, phenol free, bleach free, and ammonia free cleaner or wipe containing an EPA approved disinfectant designed specifically for cleaning gym equipment, such as GymWipes Antibacterial. Leave the disinfectant in place for the duration specified by the wipe manufacturer.
    • Wet the shaft with an alcohol free, phenol free, bleach free, and ammonia free cleaner or wipe containing an EPA approved disinfectant designed specifically for cleaning gym equipment, such as GymWipes Antibacterial.

    • Leave the disinfectant in place for the duration specified by the wipe manufacturer.

    • Please refer to the manufacturer’s instructions to determine the correct amount of time needed to leave the product on.

    • If you are using GymWipes Antibacterial, leave the product on for at least 15 seconds. The solution will be the most effective if left on for at least 4 minutes.

    • After the appropriate amount of time has passed, wipe down with a clean cloth if not already dried.

Rogue Product Development

Member since: 03/26/2020

2,955 Reputation

22 Guides authored

View Statistics:

Past 24 Hours: 7

Past 7 Days: 34

Past 30 Days: 132

All Time: 4,280